APPLICATION GUIDE

WBS ALPINE RENDER
ONTO NEW / EXISTING BLOCKWORK

For Refurbishment Only Applications
If applying directly to existing brickwork /blockwork / render surface, the substrate must be brushed down to remove any friable material, algae or lichen and fungicidal wash should then be applied. Any ridges or protrusions should be removed and hollows filled to provide a smooth surface.

For Refurbishment & New Build Applications
Stabilising solution may be applied if required to help improve adhesion and offer uniform suction.

Install all beads and trims using approved WBS fixings at a maximum of 300mm centres (depending on the substrate – please consult WBS technical department for assistance).

Mix basecoat to a pliable consistency using approximately 4-5 litres of clean water per 25kg bag. A suitable measuring bucket ensures the correct quantity and accuracy each time. Ensure that the basecoat is mixed thoroughly - it takes at least 10 minutes to dissolve the powder additives. Note how the dryish mix becomes creamy after several minutes. Mix will normally be slightly sticky.

Note: Renders with a high polymer content should be left to stand for 10-15 minutes and be remixed to break the initial set.

Do not add anything to the mix other than clean water.

Trowel apply initial coat to substrate, dubbing out to a minimum of 8mm (or to architect's specification) until a level surface is achieved.

Bed in alkali resistant reinforcing mesh into top third of basecoat (if required), ensuring that an overlap of a minimum of 75mm is achieved.

When basecoat is dry, apply additional stress patches and corner reinforcements across all window and door openings at a 45° angle.

Tidy up base rails and profiles with a damp paint brush or similar to ensure a professional finish.

Apply a slurry coat of alpine render to act as a primer.

Trowel apply a smooth coat of alpine finish at a thickness to reflect the aggregate grain size.

With a flat plastic float, rub / drag the aggregate in either a vertical, horizontal or random direction to achieve the desired final finish.

Provided strictly for guidance purposes only. For technical support please call 08458 382380.